Symptom Chart(s)

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .

Symptom Chart: NVH

Symptom Chart

Condition	Possible Sources	Actions
Driveline clunk - loud clunk when shifting from REVERSE to DRIVE	Damaged or worn Constant Velocity (CV) joints	INSPECT the Constant Velocity (CV) joints for wear or damage. INSTALL a new halfshaft as necessary. REFER to: Rear Halfshaft .
	Loose hub nut	CHECK the torque on the hub nut. REPLACE the hub nut if the torque is not at specification. For hub nuts. REFER to: Wheel Bearing and Wheel Hub - RS .
Driveline clunk - occurs as the vehicle starts to move forward following a stop	Loose hub nut	CHECK the torque on the hub nut. REPLACE the hub nut if the torque is not at specification. REFER to: Rear Halfshaft . REFER to: Wheel Bearing and Wheel Hub - RS .
Grunting - normally associated with a shudder experienced during acceleration from a complete stop	Halfshaft Constant Velocity (CV) joint binding	CHECK the outer Constant Velocity (CV) joint for correct seating into the hub. REPAIR as necessary. REFER to: Rear Halfshaft .
Driveline vibration - occurs at cruising speeds	Binding or damaged Constant Velocity CV joint	CHECK the outer CV joint for correct seating into the hub. REPAIR as necessary. REFER to: Rear Halfshaft . REFER to: Wheel Bearing and Wheel Hub - RS .