Symptom Chart
WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Symptom Chart: Vehicle Dynamic Suspension
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| Condition | Possible Sources | Actions |
|---|---|---|
| A module does not respond to the diagnostic scan tool | Fuse Wiring, terminals or connectors GFM2 concern |
REFER to: Communications Network . |
| Message center displays, DRIVE MODE NOT AVAILABLE | Low temperature operation Diagnostic Trouble Codes (DTCs) present in the GFM2 |
In low temperatures, -20°C (-4°F), the exhaust valve may freeze up and stick closed resulting in a drive mode not available message. START the engine and ALLOW the vehicle to warm up for at least 2 minutes. RETRIEVE all GFM2 Diagnostic Trouble Codes (DTCs). |
| Rough or harsh ride | Vehicle dynamic suspension system disabled | RETRIEVE all GFM2 Diagnostic Trouble Codes (DTCs). If no Diagnostic Trouble Codes (DTCs) are present, DIAGNOSE the base suspension system. REFER to: Suspension System . |
| Drive modes cannot be changed using the drive mode switch | Refer to the Pinpoint Test | GO to Pinpoint Test E |
| Suspension modes cannot be changed using the ride control switch | Refer to the Pinpoint Test | GO to Pinpoint Test C |