Pinpoint Test G : B1182:55, B1254:51, B1255:51, C1A56:51 Or C1A58:51
WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
- DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition BCM B1182:55 Tire Pressure Monitoring System: Not Configured This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC is cleared after the TPMS sensors locations are trained to the BCM. BCM B1255:51 Left Rear (Outside On Duel Wheel) Tire Pressure Sensor and Transmitter Assembly: Not Programmed This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC is cleared after the TPMS sensors locations are trained to the BCM. BCM B1254:51 Right Rear (Outside on Duel Wheel) Tire Pressure Sensor and Transmitter Assembly: Not Programmed This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC is cleared after the TPMS sensors locations are trained to the BCM. BCM C1A56:51 Left Front Tire Pressure Sensor and Transmitter Assembly: Not Programmed This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC is cleared after the TPMS sensors locations are trained to the BCM. BCM C1A58:51 Right Front Tire Pressure Sensor and Transmitter Assembly: Not Programmed This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC is cleared after the TPMS sensors locations are trained to the BCM. Possible Sources
- TPMS sensor locations not trained
- BCM configuration
- G1 CHECK VEHICLE HISTORY
- Check vehicle history for recent service action with the BCM.
Were there any recent BCM service actions?
Yes GO to G2 No GO to G3 - G2 CARRY OUT THE TPMS SENSOR TRAINING PROCEDURE
- Train all 4 TPMS sensors. REFER to: Tire Pressure Monitoring System (TPMS) Sensor Location Calibration . .
- Using a diagnostic scan tool, clear the BCM Diagnostic Trouble Codes (DTCs).
- Ignition OFF.
- Ignition ON.
- Using a diagnostic scan tool, carry out the BCM self-test.
Are there any BCM Diagnostic Trouble Codes (DTCs) present?
Yes GO to G3 No The system is operating correctly at this time. Un-trained TPMS sensors caused the DTC. - G3 PROGRAM THE BCM
- Using a diagnostic scan tool, install as-built data for the BCM.
- Ignition OFF.
- Ignition ON.
- Using a diagnostic scan tool, carry out the BCM self-test.
Are there any BCM Diagnostic Trouble Codes (DTCs) present?
Yes CHECK OASIS for any applicable Technical Service Bulletins (TSBs), GSB, SSM or FSA. If a exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new BCM refer to Body Control Module (BCM) . No The system is operating correctly at this time. The concern was caused by an incorrectly configured BCM.