Rear Stabilizer Bar Link - Vehicles With: Ball Joint Stabilizer Bar Link: Removal

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
NOTE: Make sure that the ball joint ball does not rotate.
1. On both sides. Remove the rear stabilizer bar link upper nut.
  Torque
  
  : 35 lb.ft (48 Nm)
2. Remove the rear stabilizer bar link lower nut and remove the rear stabilizer bar link.
  Torque
  
  : 81 lb.ft (110 Nm)

Courtesy of FORD MOTOR COMPANY