Rear Stabilizer Bar - ST: Removal

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

Remove the rear wheels and tires. Refer to: Wheel and Tire .
On both sides. Remove and discard the rear stabilizer bar link nut and position the rear stabilizer bar link aside.
Torque

: 35 lb.ft (48 Nm)

Courtesy of FORD MOTOR COMPANY
Remove and discard the rear stabilizer bar bracket bolts and remove the rear stabilizer bar.
Torque

: 46 lb.ft (63 Nm)

Courtesy of FORD MOTOR COMPANY
Inspect and if necessary, install new stabilizer bar bushings.