Wheel Hub - RS: Installation

WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the wheel bearing is installed into the wheel knuckle with the wheel speed sensor ring (black in color) toward the inner face of the wheel knuckle.

NOTE: Once the wheel bearing is installed, make sure the wheel speed sensor ring on the bearing and the sensor hole on the wheel knuckle are clean or damage to the wheel speed sensor or sensor ring may occur.

Install the bearing into the wheel knuckle. Use Special Service Tool: 205-153 (T80T-4000-W) Handle., 205-138 (T80T-4000-D) Installer, Drive Pinion Bearing Cup. Use the General Equipment: Hydraulic Press

Courtesy of FORD MOTOR COMPANY
Install the snap ring properly in the groove.

Courtesy of FORD MOTOR COMPANY
Install the wheel hub into the front wheel bearing. Use Special Service Tool: 205-153 (T80T-4000-W) Handle., 205-140 (T80T-4000-F) Installer, Drive Pinion Bearing Cup., 205-138 (T80T-4000-D) Installer, Drive Pinion Bearing Cup. Use the General Equipment: Hydraulic Press

Courtesy of FORD MOTOR COMPANY
Install the wheel knuckle. Refer to: Wheel Knuckle - RS .