LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1223 (Electronic Power Assist Steering Component Testing) >> PinPoint Tests >> Pinpoint Test Y: DTCs C200D, P061A, P160C, U2011 and U3000: EPAS Internal Failure DTCs >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.

This test is used to generate a RVC for a new PSCM when no additional diagnostics are required. A RVC is required to order a new PSCM and to document billing for payment.

  1. Y1: VERIFY THE PSCM DTC 
    • Clear the PSCM DTCs.
    • Ignition OFF.
    • Wait at least 90 seconds for the modules to completely shut off.
    • Ignition ON, engine OFF.
    • Retrieve the continuous memory DTCs.
    • Does the DTC return? 
      Yes No
      GO to  Y2. The condition causing the DTC is not present at this time.
      If this is a Ford paid repair, INCLUDE the RVC on the warranty claim form.
      When complete, SELECT the "X" in the top right corner to CLOSE this procedure.
  2. Y2: OBTAIN PSCM RVC 
    • Obtain the PSCM RVC: In order to claim the SLTS labor operation for completion of the PSCM testing, the code obtained through the link below must be included on the associated warranty claim.

      INSTALL a new PSCM.

      REFER to Power Steering System .

      ORDER a replacement PSCM and INCLUDE the RVC on the form.

      If this is a Ford paid repair, INCLUDE the RVC on the warranty claim form.

      When complete, SELECT the "X" in the top right corner to CLOSE this procedure.