LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1221 (Vehicle Dynamic Suspension System) >> Removal And Installation >> Front Suspension Height Sensor >> Installation

Front Suspension Height Sensor: Installation

WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: The linkage must be in a vertical position after installation. Failure to follow these instructions may result in component damage and/or failure.
    NOTE: The RH and LH height sensor assemblies cannot  be used on opposite sides of the vehicle.

    To install, reverse the removal procedure.

  2. Calibrate the suspension height sensor. Connect the scan tool and carry out the Ride Height Calibration routine. Follow the scan tool directions.
scientia non olet · About LEMON Manuals