Pinpoint Test L : U0253:87: Notes
WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Vehicle Dynamic Suspension for schematic and connector information.
Normal Operation and Fault Conditions
With the ignition ON, the APIM sends messages to the VDM over the HS-CAN 1. If the VDM does not receive these messages within a certain time frame, the module sets Diagnostic Trouble Codes (DTCs). For information on the messages sent to the VDM by the APIM, go to the Network Message Chart. REFER to: Vehicle Dynamic Suspension - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0253:87 | Lost Communication With Accessory Protocol Interface Module: Missing Message | This DTC sets in continuous memory if the message center information message is missing. |
Possible Sources
- Wiring, terminals or connectors
- Network communication concern
- APIM