LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1214 (Accessory Drive Belt System - 2.0L ECOBOOST (177KW/240PS) - Mi4) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Installation

Accessory Drive Belt Tensioner: Installation

WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: After installation, make sure the accessory drive belt is correctly seated on all the pulleys.

    To install, reverse the removal procedure.

    1. NOTE: Lubricating the grommets with silicone grease will aid in the installation of the engine appearance cover, and any future removal and installation of the cover.

      Lubricate each grommet with silicone grease.

      Material: Motorcraft ® Silicone Brake Caliper Grease and Dielectric Compound / XG-3-A (ESE-M1C171-A)

    2. Position the engine appearance cover onto engine with the grommets aligned with the studs.
    3. Press down on the engine appearance cover at each grommet location to attach the grommets onto the studs.
    GFD227516Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals