Outer Constant Velocity (CV) Joint Boot: Installation
WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
-
NOTE: Make sure that the component is clean, free of foreign material and lubricant.
Clean the outer CV joint housing.
-
NOTE: Grease sachet is supplied with boot kit.
Apply the supplied grease sachet to the inner CV joint housing. Install the outer CV joint boot.
Material: Motorcraft ® Constant Velocity Joint Grease / XG-5 (WSS-M1C258-A1)
- Using the special tool, install the new CV joint boot clamps. Use Special Service Tool: 205-343 (T95P-3514-A) Installer, Constant Velocity Joint Boot Clamp.
- Install the inner CV joint boot. REFER to: Inner Constant Velocity (CV) Joint Boot .