Front Wheel Bearing and Wheel Hub: Installation
WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
-
NOTE: Make sure the wheel bearing is installed into the wheel knuckle with the wheel speed sensor ring (black in color) toward the inner face of the wheel knuckle.NOTE: Once the wheel bearing is installed, make sure the wheel speed sensor ring on the bearing and the sensor hole on the wheel knuckle are clean or damage to the wheel speed sensor or sensor ring may occur.
Use Special Service Tool: 205-153 (T80T-4000-W) Handle., 205-480 Installer, Drive Pinion Inner Bearing Cup., 205-538 Remover, Axle Bushing. Use the General Equipment: Hydraulic Press
-
NOTE: Make sure the wheel speed sensor hole in the wheel knuckle is not blocked by the circlip. The sensor hole must be positioned between the ends of the circlip.
- Use Special Service Tool: 205-153 (T80T-4000-W) Handle., 205-140 (T80T-4000-F) Installer, Drive Pinion Bearing Cup., 205-138 (T80T-4000-D) Installer, Drive Pinion Bearing Cup. Use the General Equipment: Hydraulic Press
- Refer to: Wheel Knuckle .