Rear Toe Adjustment

WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM Color Coding

Adjustment

Using alignment equipment and the manufacturer's instructions, measure the rear toe.
NOTE: The cam nut and cam bolt area must be free of foreign material to make sure of correct clamping.

NOTE: Clean the general area of the joint to prevent foreign material from entering the joint. Clean the area using only mild liquids.

On both sides. Loosen the toe link nut approximately one full turn.

Courtesy of FORD MOTOR COMPANY
Jounce the vehicle to make sure that the suspension is in its normal, at-rest position.
On both sides. Adjust the toe setting. Rotate the toe link bolt to achieve the specified toe setting.

Courtesy of FORD MOTOR COMPANY
On both sides. Tighten the toe link nut.
Torque: 66 lb.ft (90 Nm)

Courtesy of FORD MOTOR COMPANY
Recheck the toe settings and adjust as necessary.