Image Display
WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The liftgate must remain closed for correct operation of the rear parking aid camera system.
The rear parking aid camera image is displayed by the FDIM when the reverse gear is selected. To determine the gear selector position and enable the camera display, the APIM receives the gear position message from the PCM via the High Speed Controller Area 1 (HS1-CAN) and High Speed Controller Area Network 3 (HS3-CAN), through the GWM. The camera generates a video signal any time it receives voltage (when the ignition is ON), regardless of the current configuration. If the camera is not configured properly, some features may be inoperative. The camera sends the video signal on shielded twisted pair wires to the APIM, which displays the image on the FDIM.