LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1193 (Electronic Engine Controls - 2.0L ECOBOOST (177KW/240PS)) >> Removal And Installation >> Catalyst Monitor Sensor >> Installation

Catalyst Monitor Sensor: Installation

WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. Calculate the correct torque wrench setting for the following torque. Refer to Torque Wrench Adapter Formula shown below. Use Special Service Tool: 303-476 (T94P-9472-A) Socket, Exhaust Gas Oxygen Sensor.
    G00468730Courtesy of FORD MOTOR COMPANY

    Material: Motorcraft ® High Temperature Nickel Anti-Seize Lubricant / XL-2

    Torque: 35 lb.ft (48 Nm)

    GFD228675Courtesy of FORD MOTOR COMPANY
  2. Refer to: Rear Driveshaft .

    All vehicles 

  3. GFD228111Courtesy of FORD MOTOR COMPANY
  4. GFD228673Courtesy of FORD MOTOR COMPANY
  5. Refer to: Air Cleaner Outlet Pipe .
    1. NOTE: Lubricating the grommets with silicone grease will aid in the installation of the engine appearance cover, and any future removal and installation of the cover.

      Lubricate each grommet with silicone grease.

      Material: Motorcraft ® Silicone Brake Caliper Grease and Dielectric Compound / XG-3-A (ESE-M1C171-A)

    2. Position the engine appearance cover onto engine with the grommets aligned with the studs.
    3. Press down on the engine appearance cover at each grommet location to attach the grommets onto the studs.
GFD227516Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals