LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1190 (Parking Aid System - Vehicles With: Active Park Assist) >> Diagnosis And Testing >> Parking Aid >> Pinpoint Test(s) >> Pinpoint Test B : B129C:14, B129D:14 >> Notes

Pinpoint Test B : B129C:14, B129D:14: Notes

WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Audio System/Navigation - With THX for schematic and connector information.

Normal Operation and Fault Conditions 

The PAM continuously monitors the active park assist sensor signals any time the ignition is on. When no signal is detected from an active park assist sensor, these Diagnostic Trouble Codes (DTCs) are set.

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
B129C:14 Left Front Side Sensor: Circuit Short To Ground Or Open A continuous and on-demand DTC that sets when any of the left front active park assist sensor circuits are open or the sensor signal line is shorted to ground.
B129D:14 Right Front Side Sensor: Circuit Short To Ground Or Open A continuous and on-demand DTC that sets when any of the right front active park assist sensor circuits are open or the sensor signal line is shorted to ground.

Possible Sources 

NOTE: Before disconnecting any of the active park assist sensors, verify the connectors are properly seated and latched.