LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1188 (Engine Cooling System - 2.0L ECOBOOST (177KW/240PS) - Mi4) >> Removal And Installation >> Cooling Fan Motor and Shroud >> Removal

Cooling Fan Motor and Shroud: Removal

WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
  1. NOTE: Some vehicles are equipped with a grille shutter assembly framework only. These vehicles will not have a grille shutter actuator or a grille shutter linkage.

    Refer to: Active Grille Shutter .

  2. Refer to: Air Cleaner .
  3. NOTE: Vehicle with trailer tow shown, vehicles without trailer tow similar.

    1. Trailer tow vehicles only.

    GFD228389Courtesy of FORD MOTOR COMPANY
  4. Torque: 44 lb.in (5 Nm)
    GFD228390Courtesy of FORD MOTOR COMPANY
  5. GFD228391Courtesy of FORD MOTOR COMPANY
  6. GFD228392Courtesy of FORD MOTOR COMPANY
  7. Use the General Equipment: Knife
    GFD228393Courtesy of FORD MOTOR COMPANY
  8. NOTE: Components not shown for clarity.

    Support each side of the cooling module. The cooling module must be allowed to drop 1-2 inches to allow clearance for cooling fan removal.

    GFD228394Courtesy of FORD MOTOR COMPANY
    1. Torque: 35 lb.ft (47 Nm)
    2. Torque: 18 lb.ft (25 Nm)
    GFD228395Courtesy of FORD MOTOR COMPANY
  10. Position aside.
    GFD228396Courtesy of FORD MOTOR COMPANY
  11. NOTE: Components not shown for clarity.
    GFD228397Courtesy of FORD MOTOR COMPANY
  12. NOTE: Components not shown for clarity.
GFD228398Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals