Rear Spoiler: Installation

WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.

Wipe glass clean with alcohol, allow to flash.

Courtesy of FORD MOTOR COMPANY
NOTE: If installing a new fixed glass with no primer or reusing the fixed glass (but primer coat has come off), use a template to mark and mask the primer area. Apply primer as directed.

NOTE: If reusing the fixed glass with existing primer coat, apply masking up to edge of primer to prevent application of primer outside of required area. Apply primer as directed.

NOTE: Make sure that the primer is applied as a consistent layer. Primer must be drip, streak and bubble-free.

NOTE: Make sure that the primer is not applied to the edges of the glass.

Apply/re-apply primer to glass and allow to flash for 30 minutes.

Material: Sika ® Aktivator PRO / Dow ® BETAPRIME™ 5504G / Sika ® Primer-207
On both side
- Make sure to install new side panels.
- Snap side panels into spoiler, pull tape liner, depress tape with 15lbs pressure evenly to wet out.
Courtesy of FORD MOTOR COMPANY
To install, reverse the removal procedure.