LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1178 (Climate Control System - General Information) >> Removal And Installation >> Thermostatic Expansion Valve >> Installation

Thermostatic Expansion Valve: Installation

WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
  2. NOTE: Only use the specified material to lubricate the seals.

    Install new O-ring seals.

    Material: Motorcraft ® PAG Refrigerant Compressor Oil / YN-12-D (WSH-M1C231-B)

  3. Lubricate the refrigerant system with the correct amount of clean PAG oil. Refer to: Refrigerant Oil Adding .
    1. NOTE: Lubricating the grommets with silicone grease will aid in the installation of the engine appearance cover, and any future removal and installation of the cover.

      Lubricate each grommet with silicone grease.

      Material: Motorcraft ® Silicone Brake Caliper Grease and Dielectric Compound / XG-3-A (ESE-M1C171-A)

    2. Position the engine appearance cover onto engine with the grommets aligned with the studs.
    3. Press down on the engine appearance cover at each grommet location to attach the grommets onto the studs.
    GFD227516Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals