Front Controls Interface Module (FCIM): Removal

WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation.

Using a diagnostic scan tool, begin the PMI process for the FCIM following the on-screen instructions.
Remove the floor console front trim panel.

Courtesy of FORD MOTOR COMPANY
Remove the instrument panel lower center trim panel.
- Disconnect the electrical connector.
Courtesy of FORD MOTOR COMPANY
Remove the instrument panel center speaker grille.
- Disconnect the electrical connector.
Courtesy of FORD MOTOR COMPANY
NOTE: The bottom FCIM (front controls interface module) fasteners are accessed from behind the FCIM.

Remove the 4 fasteners and the FCIM.
- Disconnect the 2 electrical connectors for access to fasteners.
  Torque: 23 lb.in (2.6 Nm)
Courtesy of FORD MOTOR COMPANY
Disconnect the electrical connectors.

Courtesy of FORD MOTOR COMPANY