Module Network Input Messages - IPC

WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.

Broadcast Message	Originating Module	Message Purpose
ABS warning indicator request	ABS module	Input used to control the ABS warning indicator.
Airbag warning indicator request	RCM	Input used to control the airbag warning indicator.
Brake (red) warning indicator request	ABS module	Input for the brake fluid level status used to control the brake warning indicator.
Driver safety belt buckle status	RCM	Input used to control the safety belt warning indicator.
High beam status	BCM	Input used to control the high beam indicator.
Ignition status	BCM	Ignition RUN, START and accessory states required for the IPC operating modes and fault reporting.
MIL request	PCM	Input used to control the MIL.
Parking brake indicator request	ABS module	Parking brake input used to control the brake warning indicator.
Parking brake status	ABS module	Input used to control the parking brake indicator.
Parklamp status	BCM	Input used to control the lights on indicator.
Rear fog lamp indicator request	BCM	Input used to control the rear fog lamps (if equipped).
Red brake warning indicator request	BCM	Input from the ABS used to control the brake warning indicator.
Stability-traction control indicator request	ABS module	Input used to control the stability/traction control (sliding car icon) indicator.
Tire pressure warning indicator	BCM	Input used to control the TPMS indicator.
Traction control mode	ABS module	Input used to control the stability/traction control disabled (sliding car OFF icon) indicator.
Transmission gear display	PCM	Input used to display or flash the PRNDL indication.
Transmission shift mode display	PCM	Input used to control the select shift segment of the PRNDL indication.
Turn indication request	BCM	Input used to control the RH turn, LH turn and hazard indicators.