LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1148 (Collision Warning System And Collision Avoidance System) >> Diagnosis And Testing >> Collision Warning and Collision Avoidance System >> Pinpoint Tests >> Pinpoint Test F : U210A:16 Or U210A:17 >> Pinpoint Test F : U210A:16 Or U210A:17

Pinpoint Test F : U210A:16 Or U210A:17

WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.

  1. F1 CHECK FOR HUD (HEAD UP DISPLAY) MODULE DIAGNOSTIC TROUBLE CODES (DTCS)

    • Engine OFF.

    • Ignition ON.

    • Using a diagnostic scan tool, clear the HUD module Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    • Retrieve Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    Is DTC U210A:16 or U210A:17 recorded? 

    Yes  GO to  F2
    No  The system is operating normally at this time. The DTC may have been set previously due to an internal intermittent fault with the temperature sensor circuit.
  2. F2 CHECK FOR CORRECT HUD (HEAD UP DISPLAY) OPERATION

    • Ignition OFF.

    • Disconnect and inspect HUD module connector.

    • Repair:

      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary

    • Reconnect the HUD module connector. Make sure it seats and latches correctly.

    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    Yes  CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new HUD. REFER to: Head Up Display (HUD) Module .
    No  The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.