LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1147 (Cruise Control System - Vehicles With: Adaptive Cruise Control) >> Diagnosis And Testing >> Cruise Control >> Pinpoint Tests >> Pinpoint Test R : U0423:82 >> Pinpoint Test R : U0423:82

Pinpoint Test R : U0423:82

WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.

  1. R1 VERIFY THE CUSTOMER CONCERN

    • Ignition ON.

    • Verify there is an observable symptom present.

    Is an observable symptom present? 

    Yes  GO to  R2
    No  The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  2. R2 CHECK THE COMMUNICATION NETWORK

    • Using a diagnostic scan tool, perform the network test.

    Does the IPC pass the network test? 

    Yes  GO to  R3
    No  REFER to: Communications Network .
  3. R3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, retrieve the GWM Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Communications Network .
    No  GO to  R4
  4. R4 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Instrumentation, Message Center and Warning Chimes .
    No  GO to  R5
  5. R5 PERFORM THE CCM (CRUISE CONTROL MODULE) SELF-TEST

    • Using a diagnostic scan tool, perform the CCM self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to DTC Chart: Cruise Control Module (CCM) .
    No  GO to  R6
  6. R6 RECHECK THE CCM (CRUISE CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)

    NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI), or the Programmable Module Installation (PMI) may not have been carried out.

    • Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs).

    • Wait 10 seconds.

    • Repeat the CCM self-test.

    Is DTC U0423:82 still present? 

    Yes  IPC Hardware Testing
    No  The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.