LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKT Livery >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center - Instrumentation, Message Center And Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test BD : DTC U0159:00 >> Pinpoint Test BD : DTC U0159:00

Pinpoint Test BD : DTC U0159:00

  1. BD1 VERIFY THE CUSTOMER CONCERN

    • Ignition ON.

    • Verify that there is an observable symptom present.

    Is an observable symptom present? 

    Yes  GO to  BD2.
    No  The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

  2. BD2 CHECK THE COMMUNICATION NETWORK

    • Using a scan tool, perform a network test.

    Does the PAM pass the network test? 

    Yes  GO to  BD3.
    No  REFER to Module Communications Network , The PAM Does Not Respond To The Scan Tool.

  3. BD3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST

    • Using a scan tool, perform the IPC self-test.

    Is DTC U3003:16 or DTC U3003:17 recorded? 

    Yes  For DTC U3003:16, GO to Pinpoint Test BJ . For DTC U3003:17, GO to Pinpoint Test BK .
    No  GO to  BD4.

  4. BD4 RECHECK THE IPC DTCs

    NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI may not have been carried out.

    • Using a scan tool, clear the DTCs.

    • Repeat the IPC self-test.

    Is DTC U0159:00 still present? 

    Yes  INSTALL a new PAM. REFER to Parking Aid Audible . CLEAR the DTCs. REPEAT the IPC self-test. If DTC U0159:00 is still present, Refer to IPC HARDWARE TESTING
    No  The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
scientia non olet · About LEMON Manuals