DTC Charts
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to Service Information for information about these diagnostic practices.
Related Module DTC Chart - BCM
| DTC | Description | Action |
|---|---|---|
| B1315:11 | Backlighting (Non Reflective Controls) Illumination Output: Circuit Short to Ground | GO to Pinpoint Test B . |
| B1315:15 | Backlighting (Non Reflective Controls) Illumination Output: Circuit Short To Battery or Open | If all non-networked backlighting is inoperative, GO to Pinpoint Test B . If all non-networked backlighting sources are always on, GO to Pinpoint Test C . |
| U1000:00 | Solid State Driver Protection Active: No Sub Type Information | The BCM has temporarily disabled an output because an excessive current draw exists (such as a short to ground). When this DTC is stored in the BCM, the backlighting output driver will be disabled until the cause of the excessive current draw has been corrected and a successful self-test has been performed. ADDRESS all other DTCs first. After the cause of the concern is corrected, CLEAR the DTCs and PERFORM the self-test. |
| U3000:49 | Control Module: Internal Electronic Failure | The BCM has permanently disabled an output due to excessive current draw. ADDRESS all other DTCs. After the cause of the concern is corrected, INSTALL a new BCM. REFER to Multifunction Electronic Modules . |
| All Other DTCs | - | REFER to Multifunction Electronic Modules . |
Related Module DTC Chart - SCCM
| DTC | Description | Action |
|---|---|---|
| B1124:09 | Lamp Fade Control: Component Failure | GO to Pinpoint Test A . |
| All Other DTCs | - | REFER to Steering System . |