Belt-Minder Deactivating/Activating

Preparation 

1. 1.
   
   Place the transmission in PARK (P).

1. 2.
   
   Turn the ignition switch to the OFF position.

1. 3.
   
   Close all the vehicle doors.

1. 4.
   
   Unbuckle the driver safety belt.

Deactivating/Activating 

If the Belt-Minder ® is already disabled, driving the vehicle with a MyKey™ programmed key overrides the deactivation, however, when the vehicle is subsequently operated using an administrator key, the Belt-Minder ® once again reverts to the disabled state.

1. 1.
   
   Turn the ignition switch to the RUN position.

1. 2.
   
   Wait until the safety belt warning indicator turns off (approximately 1 minute).

NOTE: Step 3 must be completed within 30 seconds after the safety belt warning indicator turns off or the procedure must be repeated.
1. 3.
   Buckle then unbuckle the safety belt 3 times, ending with the safety belt unbuckled.

NOTE: After Step 3, the safety belt warning indicator lamp illuminates for 3 seconds.
1. 4.
   Within 10 seconds of the safety belt warning indicator turning on, buckle then unbuckle the safety belt.
   • This disables the Belt-Minder ® feature if it is currently enabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds.
   • This enables the Belt-Minder ® feature if it is currently disabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds followed by a second series of 4 flashes per second for 3 seconds.

1. 5.
   
   After confirmation, the deactivation/activation procedure is complete.