Pinpoint Test At : The Turn Signal On Warning Chime Is Inoperative

AT1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?

Yes GO to AT2.

No Refer to IPC Hardware Testing .

AT2 CHECK THE TURN SIGNAL INDICATOR OPERATION
- Ignition ON.
- Verify the RH and LH turn signal indicators operate correctly.
Do the turn signal indicators operate correctly?

Yes GO to AT3.

No GO to Pinpoint Test S .

AT3 RETRIEVE THE RECORDED DTCs FROM THE BCM SELF-TEST

Ignition ON.

Using a scan tool, perform the BCM self-test.

Are any DTCs present?

Yes	REFER to the BCM DTC Chart in Multifunction Electronic Modules .
No	Refer to IPC Hardware Testing .