Power Transfer Unit (PTU): Removal
WARNING: This page is about a different variant/trim than selected.
- 1.
With the vehicle in NEUTRAL, position it on a hoist. Refer to Jacking and Lifting .
- 2.
Remove the intermediate shaft. Refer to Front Drive Halfshafts .
- 3.
Index-mark the driveshaft. Marker. Discard the specified component. Follow local disposal regulations.
- 4.
Remove the exhaust flexible pipe and the RH catalytic converter. Refer to Exhaust System .
- 6.NOTE: The PTU vent hose should be replaced whenever a new PTU is installed.
If equipped, disconnect the PTU vent hose.