Removal And Installation: Halfshaft: Removal

WARNING: This page is about a different variant/trim than selected.

1.

Remove the wheel bearing and wheel hub. For additional information, refer to Rear Suspension .

2.

Remove the Anti-Lock Brake System (ABS) sensor bolt and position the ABS sensor aside.

3.

NOTE: Do not damage the differential oil seal when removing the halfshaft from the differential.

Using a suitable pry bar, remove the halfshaft from the differential.
- Remove the halfshaft through the wheel bearing opening in the wheel knuckle.

GFD96504

Courtesy of FORD MOTOR COMPANY

4.

Remove and discard the circlip from the stub shaft.

GFD96488

Courtesy of FORD MOTOR COMPANY