Pinpoint Test A : The Adjustable Pedals Only Move In 1-Second Intervals: Notes

Diagnostic Overview

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to Diagnostic Methods in Service Information for information about these practices.

Refer to Adjustable Pedals , for schematic and connector information.

Normal Operation and Fault Conditions

The SCCM uses a Hall-effect sensor integral to the motor to identify the current pedal position. The SCCM sends a reference voltage along the sensor feed circuit, through the Hall-effect sensor and back to the SCCM along the signal return circuit.

When one or more of the following DTCs set, the adjustable pedals enter a "jog mode". The memory system recall will not function from either the memory set switch or the RKE transmitter while the pedals are in jog mode. The motor moves the pedals for only one second regardless of the length of time the adjustable pedals control switch is actually pressed. DTC Fault Trigger Conditions

DTC	Description	Fault Trigger Conditions
B1368:11	Adjustable Pedal Position Feedback Sensor: Circuit Short to Ground	Sets when the SCCM detects a short to ground on the Hall-effect sensor feed and/or return circuits. The SCCM continually checks for faults during normal operation when the ignition is ON and during the on-demand self test.
B1368:12	Adjustable Pedal Position Feedback Sensor: Circuit Short to Battery	Sets when the SCCM detects a short to voltage on the Hall-effect sensor feed and/or return circuits. The SCCM continually checks for faults during normal operation when the ignition is ON and during the on-demand self test.