The Belt-Minder® Deactivating/Activating

If the Belt-Minder® is already disabled, driving the vehicle with a MyKey™ programmed key overrides the deactivation, however, when the vehicle is subsequently operated using an administrator key, the Belt-Minder® once again reverts to the disabled state.

1. Turn the ignition switch to the RUN position.
2. Wait until the safety belt warning indicator turns off (approximately 1 minute).
3. NOTE:  Step 3 must be completed within 30 seconds after the safety belt warning indicator turns off or the procedure must be repeated.

   Buckle then unbuckle the safety belt 3 times, ending with the safety belt unbuckled.

4. NOTE:  After Step 3, the safety belt warning indicator lamp illuminates for 3 seconds.

   Within 10 seconds of the safety belt warning indicator turning on, buckle then unbuckle the safety belt.

   • This disables the Belt-Minder® feature if it is currently enabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds.
   • This enables the Belt-Minder® feature if it is currently disabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds followed by a second series of 4 flashes per second for 3 seconds.
5. After confirmation, the deactivation/activation procedure is complete.