LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2014 >> Navigator Base, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center - Instrumentation, Message Center, And Warning Chimes >> General Procedures >> Compass Calibration - Without Message Center

Compass Calibration - Without Message Center

  1. NOTE:  For optimum calibration, drive to an open, level location away from large metallic objects or structures. Switch off all non-essential electrical accessories (heated rear window, heater, A/C, map lamps, wiper, etc.) and make sure all the doors are closed.

    Start the vehicle.

  2. Press and release the SELECT/RESET button to scroll through the information displays until the message center displays HOLD RESET FOR SETUP MENU.
  3. Press and hold the SELECT/RESET button for approximately 2 seconds until the message center displays HOLD RESET FOR SYSTEM CHECK.
  4. Press and release the SELECT/RESET button to scroll through the system check displays until the message center displays RESET FOR CALIBRATION is displayed.
  5. Press and hold the SELECT/RESET button for approximately 2 seconds to enter the compass zone adjustment mode.
  6. Press and hold the SELECT/RESET button until the message center displays CIRCLE SLOWLY TO CALIBRATE is displayed.
  7. NOTE:  This step may require up to 5 circles to complete the calibration.

    NOTE:  If the RESET button is pressed during the calibration or 3 minutes has elapsed since the beginning of the calibration without driving the vehicle, the message center reverts back to normal operation and the INFO displays CAL until a successful calibration is carried out.

    Slowly drive the vehicle in a circle at less than 5 km/h (3 mph) until the CIRCLE SLOWLY TO CALIBRATE display changes to CALIBRATION COMPLETED.

scientia non olet · About LEMON Manuals