Pinpoint Test K: The AWD Gauge Is Inoperative

K1 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded IPC DTCs from the self-test.
  Are any DTCs recorded?
  - Yes : REFER to DTC CHARTS .
  - No : GO to K2.
K2 RETRIEVE THE RECORDED DTCs FROM THE PCM SELF-TEST
- Check for recorded AWD system PCM DTCs from the self-test.
  Are any DTCs recorded?
  - Yes : For all other DTCs, REFER to FOUR WHEEL DRIVE (4WD) SYSTEMS .
  - No : GO to K3.
K3 CHECK THE DISPLAY MODE MENU
- On the optional IPC , in the display mode menu, press the LH steering wheel switch to the right to display the AWD gauge.
- On the base IPC (Edge only), in the Information display mode, press the LH steering wheel switch to the right then down to display the AWD gauge.
  Does the AWD gauge display?
  - Yes : The AWD gauge is operating correctly at this time. The display mode was not set to correct display mode.
  - No : INSTALL a new IPC . REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.