- A module does not respond to the scan tool
|
- Fuse
- Wiring, terminals or connectors
- Module
|
|
- All dimmable illumination does not dim
|
- Refer to the Diagnostic Routine
|
|
- All dimmable non-networked illumination is inoperative
|
- Refer to the Diagnostic Routine
|
|
- All dimmable non-networked illumination is always on
|
- Refer to the Diagnostic Routine
|
|
- The steering wheel switch illumination is inoperative
|
- Refer to the Diagnostic Routine
|
|
- The LF window control switch illumination is inoperative
|
|
- VERIFY the operation of the power mirrors.
- If the power mirrors operate correctly, INSTALL a new window control switch. REFER to
GLASS, FRAMES AND MECHANISMS
.
- If the power mirrors do not operate correctly, REFER to
REAR VIEW MIRRORS
.
|
- The RF, RR or LR window control switch illumination is inoperative or always on
|
- Refer to the Diagnostic Routine
|
|
- One or more switch or component illumination is inoperative
|
- Refer to the Diagnostic Routine
|
|
- The IPC illumination is inoperative/does not dim
|
|
|
- The FCIM illumination is inoperative/does not dim
|
|
|
- The FDIM illumination is inoperative/does not dim
|
|
|
- The RHVAC module illumination is inoperative/does not dim
|
|
- Using a scan tool, PERFORM the network test.
- If the scan tool responds with no communication with the RHVAC module, REFER to
MODULE COMMUNICATIONS NETWORK
.
- If the scan tool communicates with the RHVAC module, INSTALL a new RHVAC module. REFER to
AUXILIARY CLIMATE CONTROL
.
|