Pinpoint Test Ar: The Parking Brake Warning Chime Is Inoperative

AR1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?
1. Yes : GO to AR2 .
2. No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) .
AR2 CHECK THE BRAKE WARNING INDICATOR FOR CORRECT OPERATION
- Apply the parking brake.
- Ignition ON.
- Observe the brake warning indicator.
Does the brake warning indicator illuminate?
1. Yes : GO to AR3 .
2. No : GO to PINPOINT TEST L .
AR3 CHECK THE SPEEDOMETER OPERATION
- Check the speedometer for correct operation.
Does the speedometer operate?
1. Yes : GO to AR4 .
2. No : GO to PINPOINT TEST F .
AR4 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Using a scan tool, perform the IPC self-test.
Are any DTCs recorded?
1. Yes : For DTC U0140:00, GO to PINPOINT TEST BA .
  For all other DTCs, REFER to DTC CHART - IPC .
2. No : GO to AR5 .
AR5 RETRIEVE THE RECORDED DTCs FROM THE BCM SELF-TEST
- Check for recorded BCM DTCs from the self-test.
Are any DTCs recorded?
1. Yes : REFER to the BCM DTC Chart in MULTIFUNCTION ELECTRONIC MODULES .
2. No : INSTALL a new BCM. REFER to MULTIFUNCTION ELECTRONIC MODULES .