LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2014 >> MKT Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center - Instrumentation, Message Center, And Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test BF: DTC U0212:00 >> Pinpoint Test Bf: DTC U0212:00

Pinpoint Test Bf: DTC U0212:00

  1. BF1 VERIFY THE CUSTOMER CONCERN 
    • Ignition ON.
    • Verify that there is an observable symptom present.

    Is an observable symptom present? 

    1. Yes  : GO to BF2  .
    2. No  : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  2. BF2 CHECK THE COMMUNICATION NETWORK 
    • Using a scan tool, perform a network test.

    Does the SCCM pass the network test? 

    1. Yes  : GO to BF3  .
    2. No  : REFER to MODULE COMMUNICATIONS NETWORK , The Steering Column Control Module (SCCM) Does Not Respond To The Scan Tool.
  3. BF3 RETRIEVE THE RECORDED DTCs FROM THE SCCM SELF-TEST 
    • Using a scan tool, perform the SCCM self-test.

    Are any DTCs recorded? 

    1. Yes  : REFER to STEERING COLUMN SWITCHES .
    2. No  : GO to BF4  .
  4. BF4 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST 
    • Using a scan tool, perform the IPC self-test.

    Is DTC U3003:16 or DTC U3003:17 recorded? 

    1. Yes  : For DTC U3003:16, GO to PINPOINT TEST BJ .

      For DTC U3003:17, GO to PINPOINT TEST BK .

    2. No  : GO to BF5  .
  5. BF5 RECHECK THE IPC DTCs 
    • Using a scan tool, clear the DTCs.
    • Repeat the IPC self-test.

    Is DTC U0212:00 still present? 

    1. Yes  : GO to BF6  .
    2. No  : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  6. BF6 CHECK FOR DTC U0212:00 SET IN OTHER MODULES 
    • Using a scan tool, clear all DTCs.
    • Ignition OFF.
    • Ignition ON.
    • Wait 10 seconds.
    • Using a scan tool, perform self-test.
    • Retrieve the continuous memory DTCs from all modules.

    Is DTC U0212:00 set in the BCM? 

    1. Yes  : INSTALL a new SCCM. REFER to STEERING COLUMN .
    2. No  : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) .
scientia non olet · About LEMON Manuals