Pinpoint Test At: The Turn Signal On Warning Chime Is Inoperative

AT1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?
- Yes : GO to AT2 .
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) .
AT2 CHECK THE TURN SIGNAL INDICATOR OPERATION
- Ignition ON.
- Verify the RH and LH turn signal indicators operate correctly.
Do the turn signal indicators operate correctly?
- Yes : GO to AT3 .
- No : GO to PINPOINT TEST S .
AT3 RETRIEVE THE RECORDED DTCs FROM THE BCM SELF-TEST
- Ignition ON.
- Using a scan tool, perform the BCM self-test.
Are any DTCs present?
- Yes : REFER to the BCM DTC Chart in MULTIFUNCTION ELECTRONIC MODULES .
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) .