LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2013 >> Navigator L, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Transfer Case) >> In-Vehicle Repair >> Transfer Case Rear Output Shaft Seal >> Installation

Transfer Case Rear Output Shaft Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Using the Input Shaft Oil Seal Installer, install the rear output shaft seal.
    Fig 1: Installing Rear Output Shaft Seal
    G06128037Courtesy of FORD MOTOR CO.
  2. Install the rear driveshaft. For additional information, refer to DRIVESHAFT .
scientia non olet · About LEMON Manuals