LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2013 >> Navigator Base, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center - Instrumentation, Message Center, And Warning Chimes >> General Procedures >> Compass Zone Adjustment - Without Message Center

Compass Zone Adjustment - Without Message Center

  1. Determine which magnetic zone you are in for your geographic location.
    Fig 1: Identifying Magnetic Zone Geographic Location (2 Of 2)
    G06076691Courtesy of FORD MOTOR CO.
  2. Press and release the SELECT/RESET button to scroll through the information displays until the message center displays HOLD RESET FOR SETUP MENU.
  3. Press and hold the SELECT/RESET button for approximately 2 seconds until the message center displays HOLD RESET FOR SYSTEM CHECK.
  4. Press and release the SELECT/RESET button to scroll through the system check displays until the message center displays COMPASS ZONE XX is displayed.
  5. Press and hold the SELECT/RESET button for approximately 2 seconds to enter the compass zone adjustment mode.
    6. NOTE: The zone selection increases with each subsequent button press with a range of zones from 1 to 15 scrolling back to the beginning.
  6. Press and release the SELECT/RESET button until the desired zone number appears.
  7. Release the SELECT/RESET button and allow the setup timer to expire to exit the procedure.
scientia non olet · About LEMON Manuals