LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2013 >> Navigator Base, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center - Instrumentation, Message Center, And Warning Chimes >> General Procedures >> Belt-Minder® Deactivating/Activating >> Deactivating/Activating

Belt-Minder® Deactivating/Activating: Deactivating/Activating

NOTE: The Belt-Minder® cannot be deactivated using a MyKey™ programmed key. The Belt-Minder® can only be deactivated using an administrator key. If the Belt-Minder® is already disabled, driving the vehicle with a MyKey™ programmed key overrides the deactivation, however, when the vehicle is subsequently operated using an administrator key, the Belt-Minder® once again reverts to the disabled state.
  1. Turn the ignition switch to the RUN position.
  2. Wait until the safety belt warning indicator turns off (approximately 1 minute).
    3. NOTE: Step 3 must be completed within 30 seconds after the safety belt warning indicator turns off or the procedure must be repeated.
  3. Buckle then unbuckle the safety belt 3 times, ending with the safety belt unbuckled.
    4. NOTE: After Step 3, the safety belt warning indicator lamp illuminates for 3 seconds.
  4. Within 10 seconds of the safety belt warning indicator turning on, buckle then unbuckle the safety belt.
    • This disables the Belt-Minder® feature if it is currently enabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds.
    • This enables the Belt-Minder® feature if it is currently disabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds followed by a second series of 4 flashes per second for 3 seconds.
  5. After confirmation, the deactivation/activation procedure is complete.
scientia non olet · About LEMON Manuals