LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2013 >> MKT Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster Illumination And Panel Illumination >> Diagnosis And Testing >> Instrument Cluster and Panel Illumination >> DTC Charts

DTC Charts

Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to SERVICE INFORMATION for information about these diagnostic practices.

RELATED MODULE DTC CHART - BCM

DTC Description Action
B1315:11 Backlighting (Non Reflective Controls) Illumination Output: Circuit Short to Ground GO to PINPOINT TEST B .
B1315:15 Backlighting (Non Reflective Controls) Illumination Output: Circuit Short To Battery or Open If all non-networked backlighting is inoperative, GO to PINPOINT TEST B . If all non-networked backlighting sources are always on, GO to PINPOINT TEST C .
U1000:00 Solid State Driver Protection Active: No Sub Type Information The BCM has temporarily disabled an output because an excessive current draw exists (such as a short to ground). When this DTC is stored in the BCM, the backlighting output driver will be disabled until the cause of the excessive current draw has been corrected and a successful self-test has been performed. ADDRESS all other DTCs first. After the cause of the concern is corrected, CLEAR the DTCs and PERFORM the self-test.
U3000:49 Control Module: Internal Electronic Failure The BCM has permanently disabled an output due to excessive current draw. ADDRESS all other DTCs. After the cause of the concern is corrected, INSTALL a new BCM. REFER to MULTIFUNCTION ELECTRONIC MODULES .
All Other DTCs - REFER to MULTIFUNCTION ELECTRONIC MODULES .
RELATED MODULE DTC CHART - SCCM

DTC Description Action
B1124:09 Lamp Fade Control: Component Failure GO to PINPOINT TEST A .
All Other DTCs - REFER to STEERING SYSTEM - ELECTRONIC POWER ASSIST STEERING (EPAS) .
scientia non olet · About LEMON Manuals