Clutch System Bleeding - 5-Speed Manual Transmission - MTX75
WARNING: This page is about a different car, the 2015 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Special Tool(s) / General Equipment
| Fluid Suction Gun |
| Brake/Clutch System Pressure Bleeder/Filler |
Materials
| Name | Specification |
|---|---|
| Motorcraft ® DOT 4 LV High Performance Motor Vehicle Brake Fluid PM-20 | WSS-M6C65-A2 |
Bleeding
- 1.NOTE: Make sure that the brake fluid level does not drop below the MIN mark.
Using a suction gun, drain the brake fluid reservoir to the MIN mark. Use the General Equipment: Fluid Suction Gun
- 3.
Install the following items:- Install a brake bleeder and fill the tool reservoir with brake fluid. Use the General Equipment: Brake/Clutch System Pressure Bleeder/Filler
Material: Motorcraft ® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20 (WSS-M6C65-A2)
- Install a brake bleeder and fill the tool reservoir with brake fluid. Use the General Equipment: Brake/Clutch System Pressure Bleeder/Filler
- 4.
- 1.
Open the clutch bleeder.
- 2.
Pump brake fluid into the hydraulic system using the brake bleeder. Use the General Equipment: Brake/Clutch System Pressure Bleeder/Filler
- 1.
- 7.
Pump the clutch pedal 5 times, using the full clutch pedal travel to remove any trapped air from the hydraulic system.
- 9.
Start the engine and check the operation of the clutch. If reverse gear engagement is excessively noisy, operate the clutch pedal 5 times, using the full clutch pedal travel.