Symptom Chart: Parking Brake and Actuation
WARNING: This page is about a different car, the 2013 Ford Focus and 2012 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.
REFER to: Diagnostic Methods ( DIAGNOSTIC METHODS ).
Check the operation of the parking brake system with the vehicle on a hoist and the parking brake control fully released. Check for damaged cables and install new components as necessary.
The first indication that something may be wrong in the parking brake system is a change in the feeling through the parking brake control. The parking brake not holding on an incline or dragging after being released are also indicators of system concerns.
- Verify the customer concern.
- Visually inspect for obvious signs of mechanical damage.
- If an obvious cause for an observed or reported concern is found, correct the cause.
- If the cause is not visually evident, verify the symptom and go to the Symptom Chart below.
SYMPTOM CHART
| Condition | Possible Sources | Actions |
|---|---|---|
| The red brake warning indicator is always illuminated |
|
REFER to: INSTRUMENTATION, MESSAGE CENTER AND WARNING CHIMES . |
| The parking brake does not apply/hold vehicle | Rear brake shoes out of adjustment | VERIFY rear brake shoe adjustment, ADJUST as necessary. REFER to: BRAKE SHOE ADJUSTMENT . |
|
GO to Pinpoint Test A | |
| The parking brake will not release |
|
GO to Pinpoint Test B |