Pinpoint Test AU: The Turn Signal Left On Warning Chime Is Inoperative
- AU1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
- Does the safety belt warning chime operate for approximately 6 seconds?
- Yes : GO to AU2.
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) .
- AU2 CHECK THE TURN SIGNAL INDICATOR OPERATION
- Ignition ON.
- Verify the RH and LH turn signal indicators operate correctly.
- Do the turn signal indicators operate correctly?
- Yes : GO to AU3.
- No : GO to PINPOINT TEST S .
- AU3 CHECK THE ODOMETER OPERATION
- Ignition ON.
- Verify the odometer is operating.
- Does the odometer display the current mileage (not -)?
- Yes : GO to AU4.
- No : GO to PINPOINT TEST H .
- AU4 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Ignition ON.
- Using a scan tool, perform the IPC self-test.
- Are any DTCs present?
- Yes
: For DTC U0140:00, GO to PINPOINT TEST BA .
For all other DTCs, REFER to DTC Chart - IPC .
- No : GO to AU5.
- AU5 RETRIEVE THE RECORDED DTCs FROM THE BCM SELF-TEST
- Ignition ON.
- Using a scan tool, perform the BCM self-test.
- Are any DTCs present?
- Yes : REFER to BODY CONTROL MODULE (BCM) - DTC Chart: BCM.
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) .