Rear Parking Aid Sensor: Removal
WARNING: This page is about a different car, the 2015 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This procedure can be used for all locations of the component.
- 1.
Remove the rear bumper cover. Refer to: Rear Bumper Cover - 4-Door . Refer to: Rear Bumper Cover - 5-Door .
- 2.
Remove the parking aid sensor.- Disconnect the parking aid sensor electrical connector.
- Release the tabs.
- Remove the parking aid sensor from the bracket.