Diagnostic Trouble Code (DTC) Chart: Parking Aid Module
WARNING: This page is about a different car, the 2015 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
| DTC | Description | Action |
|---|---|---|
| B129C:12 | Left Front Side Sensor: Circuit Short To Battery | REFER to: Parking Aid . |
| B129C:14 | Left Front Side Sensor: Circuit Short To Ground Or Open | REFER to: Parking Aid . |
| B129C:96 | Left Front Side Sensor: Component Internal Failure | REFER to: Parking Aid . |
| B129D:12 | Right Front Side Sensor: Circuit Short To Battery | REFER to: Parking Aid . |
| B129D:14 | Right Front Side Sensor: Circuit Short To Ground Or Open | REFER to: Parking Aid . |
| B129D:96 | Right Front Side Sensor: Component Internal Failure | REFER to: Parking Aid . |
| B129E:11 | Enable/Disable Switch - Semi-Automatic Advanced Parallel Park: Circuit Short To Ground | REFER to: Parking Aid . |
| B1303:11 | Park Assist Switch: Short To Ground | REFER to: Parking Aid . |
| B1304:00 | Electronic Power Assisted Steering: No Sub Type Information | REFER to: Parking Aid . |
| B1B36:12 | Right Front Outer Sensor: Circuit Short To Battery | GO to Pinpoint Test G |
| B1B36:14 | Right Front Outer Sensor: Circuit Short To Ground Or Open | GO to Pinpoint Test H |
| B1B36:96 | Right Front Outer Sensor: Component Internal Failure | GO to Pinpoint Test I |
| B1B38:12 | Right Front Inner Sensor: Circuit Short To Battery | GO to Pinpoint Test G |
| B1B38:14 | Right Front Inner Sensor: Circuit Short To Ground Or Open | GO to Pinpoint Test H |
| B1B38:96 | Right Front Inner Sensor: Component Internal Failure | GO to Pinpoint Test I |
| B1B40:12 | Left Front Outer Sensor: Circuit Short To Battery | GO to Pinpoint Test G |
| B1B40:14 | Left Front Outer Sensor: Circuit Short To Ground Or Open | GO to Pinpoint Test H |
| B1B40:96 | Left Front Outer Sensor: Component Internal Failure | GO to Pinpoint Test I |
| B1B42:12 | Left Front Inner Sensor: Circuit Short To Battery | GO to Pinpoint Test G |
| B1B42:14 | Left Front Inner Sensor: Circuit Short To Ground Or Open | GO to Pinpoint Test H |
| B1B42:96 | Left Front Inner Sensor: Component Internal Failure | GO to Pinpoint Test I |
| B1B44:12 | Right Rear Outer Sensor: Circuit Short To Battery | GO to Pinpoint Test E |
| B1B44:14 | Right Rear Outer Sensor: Circuit Short To Ground Or Open | GO to Pinpoint Test D |
| B1B44:96 | Right Rear Outer Sensor: Component Internal Failure | GO to Pinpoint Test F |
| B1B46:12 | Right Rear Inner Sensor: Circuit Short To Battery | GO to Pinpoint Test E |
| B1B46:14 | Right Rear Inner Sensor: Circuit Short To Ground Or Open | GO to Pinpoint Test D |
| B1B46:96 | Right Rear Inner Sensor: Component Internal Failure | GO to Pinpoint Test F |
| B1B48:12 | Left Rear Outer Sensor: Circuit Short To Battery | GO to Pinpoint Test E |
| B1B48:14 | Left Rear Outer Sensor: Circuit Short To Ground Or Open | GO to Pinpoint Test D |
| B1B48:96 | Left Rear Outer Sensor: Component Internal Failure | GO to Pinpoint Test F |
| B1B50:12 | Left Rear Inner Sensor: Circuit Short To Battery | GO to Pinpoint Test E |
| B1B50:14 | Left Rear Inner Sensor: Circuit Short To Ground Or Open | GO to Pinpoint Test D |
| B1B50:96 | Left Rear Inner Sensor: Component Internal Failure | GO to Pinpoint Test F |
| B1B54:11 | Function LED - Park Aid: Circuit Short To Ground | GO to Pinpoint Test J |
| B1B54:12 | Function LED - Park Aid: Circuit Short To Battery | GO to Pinpoint Test J |
| B1B57:11 | Front Sensors Power Circuit: Circuit Short To Ground | GO to Pinpoint Test B |
| B1B58:11 | Rear Sensors Power Circuit: Circuit Short To Ground | GO to Pinpoint Test C |
| U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | GO to Pinpoint Test K |
| U0101:00 | Lost Communication With TCM: No Sub Type Information | GO to Pinpoint Test L |
| U0121:00 | Lost Communication With Anti-Lock Brake System (ABS) Control Module: No Sub Type Information | GO to Pinpoint Test M |
| U0131:00 | Lost Communication With Power Steering Control Module: No Sub Type Information | GO to Pinpoint Test N |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test O |
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | GO to Pinpoint Test P |
| U0164:00 | Lost Communication With HVAC Control Module: No Sub Type Information | GO to Pinpoint Test Q |
| U0253:00 | Lost Communication With Accessory Protocol Interface Module: No Subtype Information | GO to Pinpoint Test R |
| U0256:00 | Lost Communication With Front Controls Interface Module "A": No Subtype Information | GO to Pinpoint Test S |
| U0257:00 | Lost Communication With Front Controls / Display Interface Module: No Subtype Information | GO to Pinpoint Test T |
| U0401:00 | Invalid Data Received From ECM/PCM "A": No Sub Type Information | This DTC sets when the PAM receives invalid network data from the PCM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0402:00 | Invalid Data Received From TCM: No Sub Type Information | This DTC sets when the PAM receives invalid network data from the TCM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0415:00 | Invalid Data Received From Anti-Lock Brake System (ABS) Control Module: No Sub Type Information | This DTC sets when the PAM receives invalid network data from the ABS module with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network |
| U0420:00 | Invalid Data Received From Power Steering Control Module: No Sub Type Information | This DTC sets when the PAM receives invalid network data from the PSCM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0422:00 | Invalid Data Received From Body Control Module: No Sub Type Information | This DTC sets when the PAM receives invalid network data from the BCM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0423:00 | Invalid Data received From Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | This DTC sets when the PAM receives invalid network data from the IPC with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0429:00 | Invalid Data Received From Steering Column Control Module: No Sub Type Information | This DTC sets when the PAM receives invalid network data from the SCCM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0554:00 | Invalid Data Received From Accessory Protocol Interface Module: No Sub Type Information | This DTC sets when the PAM receives invalid network data from the APIM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0557:00 | Invalid Data Received From With Front Controls Interface Module "A": No Sub Type Information | This DTC sets when the PAM receives invalid network data from the IPC with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0558:00 | Invalid Data Received From Front Controls / Display Interface Module: No Sub Type Information | This DTC sets when the PAM receives invalid network data from the FCDIM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U2024: 41 | Control Module Cal-Config Data: General Checksum Failure | CLEAR the DTC and carry out the PAM self-test. If DTC U2024:41 is retrieved again, PROGRAM the PAM. REFER to: Module Configuration - System Operation and Component Description . carry out the self-test. If DTC-U2024:41 is retrieved again, INSTALL a new PAM. Refer to: Parking Assist Control Module (PAM) - 4-Door . Refer to: Parking Assist Control Module (PAM) - 5-Door . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | CLEAR the DTC and carry out the module self-test. If the DTC returns, INSTALL a new PAM. Refer to: Parking Assist Control Module (PAM) - 4-Door . Refer to: Parking Assist Control Module (PAM) - 5-Door . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | CLEAR the DTC and carry out the self-test. If the DTC returns, INSTALL a new PAM. Refer to: Parking Assist Control Module (PAM) - 4-Door . Refer to: Parking Assist Control Module (PAM) - 5-Door . |
| U3000:44 | Control Module: Data Memory Failure | CLEAR the DTC and carry out the self-test. If the DTC returns, INSTALL a new. PAM. Refer to: Parking Assist Control Module (PAM) - 4-Door . Refer to: Parking Assist Control Module (PAM) - 5-Door . |
| U3000:45 | Control Module: Program Memory Failure | CLEAR the DTC and carry out the self-test. If the DTC returns, INSTALL a new. PAM. Refer to: Parking Assist Control Module (PAM) - 4-Door . Refer to: Parking Assist Control Module (PAM) - 5-Door . |
| U3000:46 | Control Module: Calibration; Parameter Memory Failure | CLEAR the DTC and carry out the self-test. If the DTC returns, INSTALL a new. PAM. Refer to: Parking Assist Control Module (PAM) - 4-Door . Refer to: Parking Assist Control Module (PAM) - 5-Door . |
| U3000:49 | Control Module: Internal Electronic Failure | CLEAR the DTC and carry out the self-test. If the DTC returns, INSTALL a new PAM. Refer to: Parking Assist Control Module (PAM) - 4-Door . Refer to: Parking Assist Control Module (PAM) - 5-Door . |