A-Pillar Trim Panel

A-Pillar Trim Panel

Removal and Installation

1. Remove the 2 A-pillar assist handle bolt covers.

2. Remove the 2 A-pillar assist handle bolts.
- To install, tighten to 5 Nm (44 lb-in).


3. NOTE: Carefully rotate the A-pillar trim panel during this step.

Remove the A-pillar trim panel.

- Pull the A-pillar trim panel outward to release the A-pillar retaining clips.


4. NOTICE: To avoid damage to the A-pillar trim panel, remove any retaining clips from the body and attach them to the A-pillar trim panel before installing.

To install, reverse the removal procedure.