Hydraulic Lash Adjuster

Hydraulic Lash Adjuster





Removal and Installation

RH cylinder head hydraulic lash adjusters

1. Remove the RH camshaft. For additional information, refer to Camshaft- RH Camshaft - RH.

LH cylinder head hydraulic lash adjusters

2. Remove the LH camshaft. For additional information, refer to Camshaft- LH Camshaft - LH.

All hydraulic lash adjusters

3. Remove the camshaft roller follower from the hydraulic lash adjuster being serviced.

4. NOTICE: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations. Failure to follow these instructions may result in engine damage.

Remove the hydraulic lash adjuster that is being serviced.


5. Inspect the hydraulic lash adjuster.

6. NOTE: Lubricate the hydraulic lash adjuster with clean engine oil prior to installation.

To install, reverse the removal procedure.