Component testing procedure
WARNING: This page is about a different variant/trim than selected.
COMPONENT TESTING PROCEDURE CHART
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Horizontal circuit | 5 and 4 9 and 3 |
Forward | Closed circuit |
| Closed circuit | |||
| 5 and 9 4 and 3 |
Rearward | Closed circuit | |
| Closed circuit | |||
| Front Height circuit | 5 and 2 6 and 3 |
Up | Closed circuit |
| Closed circuit | |||
| 5 and 6 2 and 3 |
Down | Closed circuit | |
| Closed circuit | |||
| Rear Height circuit | 5 and 1 12 and 3 |
Up | Closed circuit |
| Closed circuit | |||
| 5 and 12 1 and 3 |
Down | Closed circuit | |
| Closed circuit | |||
| Backrest circuit | 5 and 8 11 and 3 |
Rearward | Closed circuit |
| Closed circuit | |||
| 5 and 11 8 and 3 |
Forward | Closed circuit | |
| Closed circuit | |||
| Lumbar circuit | 5 and 7 10 and 3 |
Out | Closed circuit |
| Closed circuit | |||
| 5 and 10 7 and 3 |
In | Closed circuit | |
| Closed circuit |