Component testing procedure
WARNING: This page is about a different variant/trim than selected.
COMPONENT TESTING PROCEDURE CHART
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Horizontal circuit | 4 and 5 9 and 3 |
Forward | Closed circuit |
| Closed circuit | |||
| 9 and 5 3 and 4 |
Rearward | Closed circuit | |
| Closed circuit | |||
| Recline circuit | 11 and 5 8 and 3 |
Up | Closed circuit |
| Closed circuit | |||
| 8 and 5 11 and 3 |
Down | Closed circuit | |
| Closed circuit |